Alexor PC9155D-433 Guía de instalación descargar pdf (Pagina 78)

PC9155 Wireless Alarm Panel

6-5

6.5 Battery Removal/Replacement

Disconnect AC power and battery before proceeding.

Removal:

(1) Disconnect battery cable from the battery terminals.

(2) Remove GPRS/Ethernet module if present.

(3) Depress the right battery retaining bracket, simultaneously lift battery free of retaining clip.

(4) Slide battery up and right to clear the left retaining clip.

(5) Dispose of battery in accordance with local regulations.

Replacement:

(1) Remove terminal protection from battery.

(2) Install battery cable on battery spade lug terminals

(3) Slide left side of battery under the left battery retaining bracket.

(4) Insert a flat head screwdriver between the battery and right retaining bracket. Lever the right retaining bracket to the right while pressing

the battery firmly in place.

(5) If required route battery cable through wire guides and connect to the PC9155 terminal board.

Trouble [7] Wireless Device Low Battery Press [7] to scroll through specific devices with a Low Battery Trouble

1st press - Wireless Zones

2nd press - Wireless Keys

3rd press -

Wireless Keypads

4th press - Wireless Sirens

5th press - Proximity Tags

One or more wireless devices has a low

battery.

NOTE: The event is not logged to the

event buffer until the wireless device low

battery delay time expires.

Program section [377].

Replace Battery

• Verify zone operation.

• Verify that tamper and low battery condition is cleared and reported.

A flashing Trouble LED on a keypad indicates that it's battery is low.

To determine which indoor siren is in low battery, press the test button.

If no test indications are sounded, replace the batteries.

To determine which outdoor siren is in low battery, remove the battery

and reconnect it. If the strobe doesn't flash, replace the battery.

If a proximity tag is in low battery, the tag must be deleted and replaced

before the trouble will be cleared from [*][2].

NOTE: Replacing batteries will cause a tamper condition. Replacing the

cover will clear the tamper causing the associated reporting codes to be

sent to the central station.

Trouble [8] Loss of Clock

Loss of Time & Date The main panel internal clock is not set. To program the time and date:

• Enter [][6][Master Code] then press [1].

• Enter the time and date (in military) using the following format:

HH:MM MM/DD/YY

Example: For 6:00 pm, Nov. 30, 2008

Enter: [18] [00] [11] [30] [08]

Ensure red cable is connected to the positive (+) terminal and the black cable is connected to the negative (-) terminal.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 87 88

Comentarios a estos manuales

Sin comentarios

Alexor PC9155D-433 Guía de instalación Pagina 78

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Alexor PC9155D-433