Alexor PC9155D-433 Guía de instalación descargar pdf (Pagina 16)

PC9155 Wireless Alarm System

2-8

2.6 GPRS/Ethernet Module Setup/Initialization

Step

Enter a 2 digit zone number, keypad number, or siren number depending on the

placement test section entered, or scroll to the desired device and press to

begin individual placement test.

Step

Place the wireless device in the intended mounting location.

Activate the device as described in the associated installation sheet.

• If the alarm system receives a STRONG signal the bell will sound once and ‘Location

is Good’ will be displayed on the LCD.

• If the alarm system receives a WEAK signal the bell will sound 3 times and ‘Location

is Bad’ will be displayed on the LCD.

• If the alarm system indicates no response, reposition wireless device and repeat

test.

Step

Repeat Step 3 for each device. Once the placement test is complete for the device,

press [#] once and select the next similar device.

When placement testing is complete, press to exit Installer

Programming.

Perform the following after system installation and programming:

Ensure that the following sections are programmed:

• Central Station Phone Number,(Template Programming - Entry 5)

(if applicable, in sections [301]-[303] & [305])

• Account code, section [310], (Template Programming - Entry 6)

• Communications Format, Section [350]- set to [04] SIA FSK

• GPRS/Ethernet Module Enable section [382] Option[5] - set to GPRS/Ethernet Module Enabled

Activate Device

Location is Good

Activate Device

Location is Bad

System is

Ready to Arm <>

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

Sin comentarios

Alexor PC9155D-433 Guía de instalación Pagina 16